The Verbrator® is a new multipurpose pedal which combines an all-tube effects loop with a studio grade reverb featuring a 32-Khz clock speed for full 16-K audio bandwidth. The Verbrator® is the most innovative Plush pedal offering to date. It’s an effects loop, it’s a reverb, it’s both!
Unlike other "tube pedals," the Verbrator® power supply features a unique regulated switching technology that takes the incoming 9 volts and converts it up to the optimal high voltage a tube really needs to operate best. In addition, a 6-volt DC regulator provides consistent clean DC power for the tube filament assuring lowest noise and consistent performance despite any changes to incoming line voltage.
The Verbrator® can be used as a pedal on a pedal board as a reverb pedal. It features a level control and decay control allowing you to have a short medium or long decay reverb algorithm. It can also be used as a tube buffer to convert an incoming high impedance signal to a low impedance for long cable runs or driving a pedal board. The recovery (gain) stage can be used to boost the level of a guitar or pedal board with a true tube audio stage. It provides a warm sweet utility gain stage with a multitude of uses.
The effects loop portion of the pedal features a unity gain cathode follower to work with any amp that has passive preamp output - power amp input patch jacks, and not a true active effects loop like Ceriatone, Dumble, Bludotone, Brown Note, some Marshall models and others. It has a send level control and high headroom. The return portion of the loop features a high impedance input (250-K) and a low output impedance with its own level control as well. The loop can be run in series or parallel modes, and features a level adjust switch for rack or pedal style effects. This is what a DUMBLEATOR does.
This will allow running a stompbox pedal like a Chorus or Delay in an amp's effects loop without a volume drop or other tone degradation.
9-volt DC adaptor provided. This is a 2amp 9V switching power supply, it will work in any country but it has a USA plug on it so you may need a pin adaptor to plug it into your power jack if you don't have a USA style AC power outlet available.
The Verbrator® features a unique “window” showing the tube. Like all Fuchs pedals, the Verbrator® features solid cast aluminum powder coated enclosure with heat cured silk screening, dual sided heavy circuit boards, premium switches and controls, and premium electronic parts throughout.