Ernie Ball Volume and Wah Pedals presented by Analog Man

The design and development of the Ernie Ball pedals has been a team effort of guitar players and craftspersons. Pedal bodies are an aluminum extrusion rather than a casting resulting in greater strength, uniformity, and smoother surfaces. Clear anodized grain finish insures lasting beauty. Overall dimensions: 4" W x 11" L x 2.5" H. The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. The large center shaft diameter, in addition the strength factor, creates a broader stress bearing surface. Our bodies and shafts are designed to give the player an indefinite service life! Deck mat of non-slip material is impervious to oil, alcohol, and most things you might spill on it. Quick disconnect wiring harness allows changing the pot without soldering. Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs. This drive design results in smooth and quiet operation qualities lacking in gear driven models. Cycle tests are made on every pedal to insure perfect operation prior to packaging.

If your pedal ever wears out after years and years of use, you can send it to Ernie Ball for a complete rebuild. They will replace every part except the case, for a reasonable charge. There is a 6 month warrantee on these pedals.